![]() As the headphones are of open-air design, sounds go out through the headphones.Avoid listening to the unit in situations where hearing must not be impaired, for example, while driving or cycling. At a high volume outside sounds may become inaudible.Avoid playing the unit at so loud a volume that extended play might affect your hearing.When you take off the headphones, move the earbuds up and down gently. Do not remove the earbuds from your ears suddenly.Do not insert the earbuds forcefully into your ears.Otherwise, you may damage your ears or eardrums. When you use in-ear headphones with a high degree of adhesion, note the following.in the United States and in other countries. The N-Mark is a trademark or registered trademark of NFC Forum, Inc.After you double-click the file, select a language. ![]() To read it, open the following folders in the system storage after you connect the unit to your computer. For information on laws, regulations, and trademark rights, refer to "Important Information" in the internal memory of your unit.Check that the computer recognizes the Walkman after you have connected it to the computer for about 10 minutes.Ĭompliance & Information Information on laws and trademarks When you use your Walkman for the first time, or if you have not used the Walkman for a long time, it may take a few minutes to be recognized by the computer.The charge lamp on the Walkman lights up in orange while the battery is charging, and goes off when the charging is completed.Disconnect the USB cable, and then reconnect it. The USB cable (supplied) is not connected to a USB connector on your computer properly.Your Walkman cannot charge the battery or is not recognized on your computer. Pairing information is deleted from the devices, such as when the devices are repaired.One or both of the devices are reset to the factory settings.Pairing information is deleted in the following situations.Tap the connecting device name on the paired device list, and tap on the disconnection dialog.Select the device from the paired device list to make the Bluetooth connection.Turn on the paired Bluetooth audio device and set it to standby.After the Bluetooth connection is established, is displayed.Īfter the Bluetooth connection is established, is displayed. Tap the Bluetooth switch ( ) to turn on the Bluetooth function.(Refer to the device's instruction manual.) Set the Bluetooth audio device to pairing mode.When you connect Bluetooth audio devices wirelessly for the first time, the devices must be registered to each other. Refer to the "Help Guide" for details on using the Bluetooth function. You can also listen to music stored on your smartphone or computer through the Walkman. You can listen to music stored on your Walkman from Bluetooth audio devices such as headphones or speakers. To prevent deterioration of the battery, charge the battery at least once every 6 months.īe sure to read the instructions for microSD cards in the Help Guide on the Internet before you store content on a microSD card (not supplied).
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |